How to use the vibration absorber in CNC four-axis machining?

CNC four-axis machining is a good solution to the complex, precision, small batch, multi-variety parts processing problems,

It is a flexible and efficient automatic machine tool, which represents the development direction of modern machine tool control technology and it's a typical mechatronics product.

Stainless steel processing can be used for indexing head clamping, also can be used four axes. Compared with the four axis,it is not convenient to use the dividing head if the number is more, because you have to calculate the Angle, and you have to do it by hand, quite troublesome, it is easy to make mistakes.

Compared with ordinary machine tools, CNC four-axis machining has higher machining accuracy and very stable machining quality.Therefore, for the operator's quality requirements are relatively high, especially in the damping device, should pay attention to the following methods of use:

1. After the machine is horizontal, tighten the screw flat and fix the horizontal state.

2. Put the required iron pad into the hole at the foot of the machine tool, insert the screw into it, hold the foot with the nut, and place the nut in contact with the machine tool.

3. Because of the creep phenomenon of rubber, in the first use of the pad iron, adjust the level of the machine again after two weeks.

4. Adjust the machine tool horizontally, rotate the nut counterclockwise and raise the machine tool.

It is very important to use the vibration absorbing device of CNC four-axis machining correctly, therefore, it is necessary to grasp the above four methods of use.