What should be paid attention to in the use of the chip discharging machine used by CNC machining fa

What should be paid attention to in the use of the chip discharging machine used by CNC machining factory?

Pengshun is a professional company engaged in precision parts processing, complex parts processing, titanium alloy parts processing and non-standard parts processing, we are focusing on semiconductor, new energy, medical, photography and optical communication and other fields.What should be paid attention to in the use of the chip discharging machine used by CNC machining factory?

1. The sprocket of the chip discharge device is equipped with overload safety clutch, and the chip discharge machine is adjusted during the factory debugging.

2. Before plugging in the power supply, it is necessary to check whether the lubricating oil of the reducer is lower than the oil level. If not, please add No.40 total loss system oil to the oil level line.

3.After starting the motor, it is necessary to check whether the rotation direction of the sprocket is the same as the direction indicated by the arrow.If not, pls correct immediately.

4.If friction plates interact with the electromechanical motor that is starting to discharge debris,the operation should be stopped immediately to check whether the chain is stuck by foreign objects or other things.After the CNC machining factory finds out the cause of the chip discharge machine's fault, it can remove the fault, and then it can start the motor again.If the chip machine can be run, it means that the fault has been successfully eliminated, if it is still not running smoothly, you can find the reason from the following two aspects.

Is the friction disc clamping force of the chip discharging machine enough? After determining the chip discharging machine, it is necessary to check whether the compression amount of the butterfly spring is within the range of the specified value. The free height of the butterfly yellow dye is generally 8.5mm, and the compression amount is 2.6-3mm.

Assuming that it is within the specified range, the compression force is sufficient.If the compression force is insufficient, three M8 compression nuts should be tightened evenly.If the slide continues after compression, the cause of the jam and the reasonableness of the chip removal machine should be checked, which is usually measured according to the requirements of CNC machining manufacturers.