Machining methods and techniques for large aluminum alloy parts

clamping method should be reasonable when doing large aluminum alloy parts. For the rough cutting,pls use the fly-cutter as much as possible if you can,this also can increases efficiency.However, it is easy to cause the workpiece to be heated and deformed when doing the rough cutting with the fly-cutter,so you have to do the front and back first to prevent the deformation,after roughing, the two surfaces should be swept flat to ensure that the workpiece is vertical and then fine machining,the thickness margin should be left enough, so as to ensure that there is also the possibility of remedial action if an anomaly processing occurs.

Clamping must be stable,avoid moving the workpiece in the process of machining when doing rough cutting,after roughing, check the parallelism with the calibration table,pay more attention to the structure of the workpiece,anticipate the position where the tool may vibrate in advance,set the speed parameter reasonably to avoid overcutting.Be careful to avoid bumping when getting on and off the machines,the empty places and thin places of the workpiece should be propped up to avoid shaking the tool knife when machining the back side, be sure to pay attention to every little detail.

The cost of loss and time is particularly large if there is any abnormality in the processing of large aluminum alloy parts,so every link must be careful.We try to choose machining tools for aluminum,if there are deep holes or deep grooves, be sure to blow off crumbs in time,avoid tool stranding aluminum slag.

We have professional and rapid solutions for processing all kinds of large aluminum alloy cavity parts, specializing in making all kinds of difficult and high-precision products.We have a professional team in the industry, excellent equipment, testing instruments and professional aluminum alloy processing experience.